Full steps show you How to install the LED display sending card

It is quite normal that the clients would choose to use their own PC to control the LED display.
In this case, you would need to install the sending card and graphic card (usually the computer with the graphic card itself ,so will usually no need install again) to your PC. Here we will show you the process steps by steps how to install the LED display sending card.

Before starting, please get in hand the parts as below:

 

 

Please power off the PC and follow the steps as below:

1.Connect the DVI Graphic Card (we provide) to the PCI-E (or AGP) of the computer motherboard (main board, system board). Then connect the DVI Graphic Card to the PC monitor, via the VGA port.

 

2.Connect the Sending Card to the PCI of the computer motherboard (main board, system board). 

 

3.Connect the DVI Graphic Card to the Sending Card, by the DVI cable provided.

 

4.Connect the Sending Card to the USB port of the computer.

5.Connect the signal cable to the Sending Card (either one of the RJ45 ports).

    

6.Turn on the PC, and check the indicator light of sending card. (Red on, Green flicker)

 

Please do not hesitate to contact us if the indicator light showing not normal.
Our After-Sale support team is ready for 7*24 hours!

For further information of our LED display products, please do not hesitate to contact us!